Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad Installation Instructions - Manual (Page 13)

Industrial Integrated Display Computers with Keypad 13
Rockwell Automation Publication 6180P-IN001C-EN-P - July 2013
Connect to the Network
The computers have dual Gigabit LAN ports. The computers connect to an Ethernet network,
using CAT5 or CAT5E twisted-pair Ethernet cabling with RJ-45 connectors.
Replace the RTC Battery
The computers use nonvolatile memory that requires a battery to retain system information
when power is removed. The 3V, 200 mAh lithium battery is on the system board.
IMPORTANT To prevent performance degradation of Ethernet communication, do not subject the computer
or cables to extreme radiated or conducted high-frequency noise.
Proper cable routing and power conditioning is required to ensure reliable Ethernet
communication in industrial environments. Rockwell Automation recommends that you route
all Ethernet cabling through dedicated metal conduits. Installing ferrite bead filters at the
cable ends may also improve reliability.
Battery