Rockwell Automation 6189V-SLDUAL Optical Disc Drive (ODD) - Manual (Page 5)

Optical Disc Drive (ODD) 5
Publication 6177R-IN004B-EN-P - November 2009
Pre-installation Procedure
Perform this pre-installation procedure before removing the side cover or accessing a
hardware component.
1. Turn off the computer and all peripherals connected to it.
If necessary, label each one to expedite reassembly.
2. Disconnect power from the computer to avoid exposure to high energy levels.
3. Disconnect telecommunication cables to avoid exposure to shock hazards from
ringing voltages.
Install the Optical Disc Drive (ODD)
You can install or replace the ODD in your computer. The computers support slim type
CD-ROM, DVD-ROM/CD-RW, and DVD-RW drives.
Remove the Side Cover
Follow these procedures to remove the cover of the computer.
1. Perform the pre-installation procedure.
2. Unfasten the side cover from the system chassis by removing the two screws located
on the rear edge of the side cover.
IMPORTANT Make sure to read and understand the entire installation or removal procedure
before you begin to configure the computer hardware.
IMPORTANT When installing hardware components that require access to internal
components, first back up all computer data to avoid loss of data.