Rockwell Automation 6189V-SLDUAL Optical Disc Drive (ODD) - Manual (Page 7)

Optical Disc Drive (ODD) 7
Publication 6177R-IN004B-EN-P - November 2009
Replace the Optical Disc Drive (ODD)
Follow this procedure to install or replace an ODD.
1. Disconnect the the interface cable from the ODD backplane board.
This cable contains both IDE data and power to the drive.
2. Cut the cable tie closest to the ODD backplane connector.
3. Remove the ODD assembly from the computer.
a. Remove the two screws securing the ODD carrier to the system drive cage.
b. Detach the ODD from the system drive cage.
4. Remove the ODD module from its carrier.
a. Remove and discard the four screws securing the ODD module to its carrier.
b. Remove the two screws securing the ODD backplane board.
Retain these screws for reassembly.
c. Detach the ODD backplane board from the ODD module.
a
b