Rockwell Automation 2706-PxM_PxK_PxP InView Communication Module Installation - Manual (Page 5)

InView Communication Modules 5
Publication 2706-IN015E-EN-P - May 2007
6. Connect the incoming serial wires to the TB1 terminal block.
7. Torque the cable grip cap until the cable is securely fastened.
8. Replace the power supply back-cover with the six screws, torquing the
screws to 2.7 Nm (24 lb-in).
9. Connect the power supply to a power source.
Mount the Communication Module to the 2706-P72 and 2706-P74
Displays
The 2706-P72 and 2706-P74 displays are equipped with a mounting plate inside the
case for mounting the 2706-P_K communication kit.
Follow these steps for mounting the communication kit.
1. Disconnect power to the InView display.
TIP
Be sure to place the wires so they are not caught by screws when replacing the
power supply cover and so they do not interfere with fan operation.
TIP
The 2706-PxM communication modules are powered through the serial cable
by the display (series C).
ATTENTION
Hazardous voltage. Contact with high voltage may cause death or serious
injury. Always disconnect power to the InView display prior to servicing.
Black (GND)1
Red (PWR, +5V)2
Orange (TX)3
Brown (RX)4
5
6
7
8
Incoming
Serial Wires
TB1 TB1
Incoming
Serial Wires