Rockwell Automation 2706-PxM_PxK_PxP InView Communication Module Installation - Manual (Page 8)

8 InView Communication Modules
Publication 2706-IN015E-EN-P - May 2007
3. Install the communication module to the mounting plate located near the
TB1 terminal block by using the supplied standoffs and screws.
4. Torque the screws to 0.68 Nm (6 lb-in).
Wire the Communication Module to the 2706-P92 and 2706-P94 Displays
The power to the communication module is provided by the InView display.
Follow these steps for wiring the communcation module.
ATTENTION
A label is included in the hardware kit that indicates the default IP address for
the 2706-PENETK EtherNet/IP communication module. The module is shipped
with a default IP address of 192. 168. 1.1. Please consult with personnel who
will be configuring communication for the most appropriate placement of the
label.
Front Cover
Communication Module