Rockwell Automation 6158 Industrial 21 inch CRT Monitors - Manual (Page 18)

18 Industrial 21" CRT Monitor
Publication 6158-5.0
Preparation for Shipment
If it is ever necessary to ship the monitor, first remove it from the panel
in which it has been installed, then securely pack it. To remove the
monitor from the panel, reverse the installation procedure that begins on
page 7. Whenever possible, ship the monitor in its original container.
ATTENTION: Never try to ship the monitor while it is
mounted in a panel. Doing so could result in damage to
the panel or monitor.
Cleaning instructions
Occasionally clean the monitor panel and cabinet with a soft cloth
dampened (not soaked) with a mild household detergent (non-abrasive).
Ensure that air vents are cleared of dust.
The screen may be cleaned with a soft cloth dampened with a mild glass
cleaner. Keep turning a fresh side of the cloth toward the screen surface
to avoid scratching it with accumulated grit. To minimize the risk of
abrasion, allow the screen to stand dry.
Special care should be taken when cleaning a resistive touchscreen or
polycarbonate shield that is installed over the CRT screen. The surface
can be easily damaged by abrasive and certain chemical cleaners. Never
use alcoholic or ammoniac cleaners.
Replace air filters over fans or heat exchanger intakes periodically to
ensure proper air flow for cooling. (Applicable to units in some industrial
enclosures.)
Maintenance