Rockwell Automation 6158 Industrial 21 inch CRT Monitors User Manual
Page 9
Industrial 21" CRT Monitor
9
Publication 6158-5.0
6.
Secure the unit with the locknuts and washers provided. Tighten
evenly to 24 inch–pounds of torque.
Important:
To assure a proper seal, be sure to install a washer and nut
on each of the 18 mounting studs.
ATTENTION: Mounting nuts must be tightened to a
torque of 24 inch–pounds to provide panel seal and avoid
potential damage. Rockwell Automation assumes no
responsibility for water or chemical damage to the
monitor or other equipment within the enclosure due to
improper installation.
7.
Remove the protective adhesive sheet from the screen of the
industrial monitor. The sheet is designed to prevent scratching of the
polycarbonate screen protector or the optional touchscreen during
shipping and installation. It should be removed before use.