Rockwell Automation 2755 AdaptaScan Mounting Bracket Kit - Manual (Page 3)

Catalog No. 2755-NM42
Instructions
AdaptaScan Mounting Bracket
3
Install the safety wire whenever the mounting bracket is installed in an
inverted position. The safety wire prevents the Reader from dropping to the
floor when the bracket locking knob is loosened.
Attaches to
Mounting Plate Screw
Loosen Locking Knob
to Remove Clamping Nut
Safety Wire
Clamping Nut
Place one end of the safety wire under a mounting bracket clamping nut.
With the bracket locking knob loosened, the clamping nut can then be
removed. The other end of the safety wire is attached to the Reader using
one of the screws that secure the mounting plate to Reader wiring base.
Installing the
Safety Wire