Rockwell Automation 2755 AdaptaScan Mounting Bracket Kit - Manual (Page 4)

Catalog Number 2755-NM42
Instructions
AdaptaScan Mounting Bracket
4
The mounting plate is attached to the bottom of the wiring base with three
screws (provided with wiring base). The mounting bracket post is threaded
into the hole at the center of the mounting plate. Lock the bracket in position
by tightening the locking knob. For additional security, you can remove the
locking knob and replace it with the hex bolt provided. The two hex socket
screws are not used in this configuration.
Mounting Plate to Reader Screws
Mounting Plate
Mounting Post
Adjustable Mounting Bracket
(Hardware Provided with Base)
Bracket Locking Knob or
Bolt (5/16 x 1 inch)
See Side Mounting Illustration Next Page
Screws Into Mounting Plate
Adjustable Mounting Bracket
Wiring Base
3 Mounting Holes
(9/32 inch diameter)
Top Post Mounting