Rockwell Automation 2706-PENI_PDNI InView EtherNet/IP Module and InView DeviceNet Module Install Inst - Manual (Page 5)

Publication 2706-IN010C-MU-P
InView EtherNet/DeviceNet Module 5
Below is a picture and description of the InView EtherNet/IP and
DeviceNet Interface module and its connectors with relation to an
InView Display.
The PENI module requires a separate 24V dc power supply. The
power supply cable diameter must be between 0.069 in to 0.260 in
(1.75 mm to 6.60 mm). The PENI module Ethernet cable installed must
have a radius of at least 0.5 in (12.7 mm).
Wiring the EtherNet/IP
Module to InView Display 1. Disconnect power to InView display.
2. Remove the power supply cover (on 2706-P4x) by unscrewing
its six screws. Set the screws and cover aside for later step.
NEMA Type 4X Enclosure with Removable Cover
Torque Enclosure Cover screws to 1.1 Nm (10 in-lb).
Customer-supplied
Ethernet/DeviceNet cable
through NEMA-rated
supplied connector
PENI Power Cable
Back of InView Display (P42, P43, P44)
Serial cable to be
connected to terminal
block inside power supply
cover on back of InView
display
2706-PENI/2706-PDNI
ATTENTION
!
Hazardous voltage. Contact with high voltage
may cause death or serious injury. Always
disconnect power to the InView display prior
to servicing.
2706-P42, 2706-P43, 2706-P44