Rockwell Automation 2706-PENI_PDNI InView EtherNet/IP Module and InView DeviceNet Module Install Inst - Manual (Page 6)

Publication 2706-IN010C-MU-P
6 InView EtherNet/DeviceNet Module
Open the front of the sign case (on 2706-P7x) by turning the
latches to the left. Carefully let the front of the case drop
forward.
3. Feed the serial cable through the cable grip (shipped with
module).
4. Insert the serial wires through the right conduit opening on
either the top or the bottom of the InView display.
5. Mount the cable grip to the InView display housing. Tighten the
locknut finger-tight and rotate an additional 1/2 turn.
6. Connect the incoming serial wires to the TB1 terminal block.
POWER LOAD EARTH GROUND
Quarter-turn latches
Front view, closed
Front view, open
EPROM unit (on
underside of board)
Controller board
2706-P72,
2706-P74
Power Line
Insert the serial wires
with the cable grip into
one of these conduit
openings.
TB1 Terminal Block for serial connection
Incoming
serial wires
TB1
(NC) 8
(NC) 7
(NC) 6
(NC) 5
(RS-232 RX) 4
(RS-232 TX) 3
(NC) 2
(GND) 1
Brown (Rxd)
Orange (Txd)
Blue (GND)
TB1 Terminal Block