Rockwell Automation 1797-CEC FLEX Ex Bus Isolator and Flexbus Connector - Manual (Page 12)

12 FLEX Ex Bus Isolator and Flexbus Connector
Publication 1797-5.13 - June 2010
European Communities (EC) Directive Compliance
If this product has the CE mark it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet
the following directives.
EMC Directive
These products are tested to meet the Council Directive 2004/108/EC by
applying the following standards:
 EN 61000-6-4:2007, Electromagnetic Compatibility (EMC) - Part 6-4:
Generic Standard for Industrial Environments (Class A)
 EN 61000-6-2:2005, Electromagnetic Compatibility (EMC) - Part 6-2:
Generic Standards - Immunity for Industrial Environments
 EN61326-1:2006 (Industrial), Electrical Equipment For
Measurement, Control, and Laboratory Use - Industrial EMC
Requirements
ATEX Directive
The 1797-BIC module is tested to meet the Council Directive 94/9/EC
(ATEX) Equipment and Protective Systems Intended for Use in Potentially
Explosive Atmospheres by applying the following standards:
 EN60079-11:2007, Explosive atmospheres - Part 11 : equipment
protection by intrinsic safety "i"
 EN60079-0:2006, Electrical apparatus for explosive gas atmospheres -
Part 0 : general requirements
 EN 60079-26 : 2004, Electrical apparatus for explosive gas
atmospheres - Part 26 : construction, test and marking of Group II
Category 1 G electrical apparatus
 EN61241-0 : 2006, Electrical apparatus for use in the presence of
combustible dust - Part 0: General requirements
 EN61241-11:2006, Electrical apparatus for use in the presence of
combustible dust – Part 11: Protection by intrinsic safety 'iD'