Rockwell Automation 1797-CEC FLEX Ex Bus Isolator and Flexbus Connector - Manual (Page 13)

FLEX Ex Bus Isolator and Flexbus Connector 13
Publication 1797-5.13 - June 2010
The 1797-CEC module is tested to meet the Council Directive 94/9 EC
(ATEX) Equipment and Protective Systems Intended for Use in Potentially
Explosive Atmospheres by applying the following standards:
 EN 60079-15:2005, Electrical Apparatus for Potentially Explosive
Atmospheres - Type of Protection “n”
FM Compliance
If this product has the FM mark, it has been designed, evaluated, tested, and
certified to meet the following standards:
 FM C1. No.3600:1998, Electrical Equipment for Use in Hazardous
(Classified) Locations General Requirements
 FM C1. No.3610:1999, Intrinsically Safe Apparatus and Associated
Apparatus for Use in Class I, II, III Division 1 Hazardous (Classified)
Locations
 FM C1. No.3615:1989, Explosionproof Electrical Equipment General
Requirements
 FM C1. No.3810:1989, 1995, Electrical and Electronic Test,
Measuring and Process Control Equipment
 ANSI/NEMA 250, 1991, Enclosures for Electrical Equipment
USL Compliance
If this product has the UL mark, it has been designed, evaluated, tested, and
certified to meet the following standards:
 UL 913, 5th Edition, Intrinsically Safe Apparatus and Associated
Apparatus for Use in Class I, II, III, Division 1, Hazardous
(Classified) Locations
 UL 1604, 3rd Edition, Electrical Equipment for Use in Class I and II,
Division 2, and Class III Hazardous (Classified) Locations
 UL 1203, 2nd Edition, Explosion-Proof and Dust-Ignition-Proof
Electrical
 Equipment for Use inHazardous (Classified) Locations
 UL 2279, 1st Edition, Electrical Equipment for Use Class I, Zone 0, 1,
and 2 Hazardous (Classified) Locations