Rockwell Automation 2711E-ND7 Installing the PanelView Serial Firmware Upgrade Utility - Manual (Page 5)

Installing the PanelView
t
Serial Firmware Upgrade Utility 5
To complete the setup, enter any required information and insert
the second disk when prompted.
Do not cancel the installation while it is in progress. If you want
to undo the installation, let the installation finish, then use the
Uninstall Serial Firmware Upgrade Utility to remove all the
installed files and to update the registration.
9. When the installation is complete, remove the disk from the
drive.
The Serial Firmware Upgrade Utility Version 3 (SFU) software is
provided on CD.
The software installation program creates a directory on your hard
drive for the SFU and copies all necessary files to it. By default, the
drive and directory is C:\AB\PB1400E\SFU. You can change this
default.
To install SFU:
1. Start Windows 95/3.x. If you’re already in Windows, close all
open Windows applications.
2. Insert the CD in the drive.
3. Browse the CD for file “SFU_V3”. Browse Disk 1. Run
“SETUP.exe”.
4. Close all applications, and then choose Next. The Serial
Firmware Upgrade Utility Installation Program runs
automatically.
5. Enter the required information.
6. Choose the drive and directory in which the SFU will be
installed. By default, this is C:\AB\PB1400E\SFU. To change the
destination drive or directory, type the new drive and/or directory
in the Program Files field. Choose Next.
7. Choose the program folder (program group) in which you want to
install the SFU icons, which includes a Readme file icon, the
Upgrade Utility icon, and an Uninstall icon. By default, the icons
are installed in the PanelBuilder 1400e program folder. Choose
Next.
8. Follow the setup instructions as they appear on your screen.
To complete the setup, enter any required information and insert
the second disk when prompted.
Installing SFU from the
“PanelBuilder 1400e
Transfer Utilities” CD onto
Windows 95 or Windows 3.x