Rockwell Automation 9904-PCIC ControlNet 9904-PCIC Communications Card I.I. - Manual (Page 13)

ControlNet PCI Communication Interface Card 13
9904-IN002A-US-P - March 2000
Table B ControlNet status interpretation
A and B
Cause: Action:
off • no power • none or apply power to the PC
• PCIC driver not
started • start PCIC driver
• verify that the PCIC driver has been
configured properly
• faulted card • check operating system event log for
details of fault (if the PC’s operating system
supports an event log)
•
cycle power to the PC
•
verify that you have firmly inserted the PCIC
card into a PCI local bus expansion slot and
that the expansion slot screw is tightened.
• If fault persists, contact a representative
where you purchased this product.
steady red • faulted card • cycle power to the PC
• verify that you have firmly inserted the PCIC
card into a PCI local bus expansion slot and
that the expansion slot screw is tightened
•
If fault persists, contact a representative
where you purchased this product.
alternating red/green • self-test • none
alternating red/off • incorrect node
configuration
• duplicate
ControlNet node
address
• check PCIC node address and other
ControlNet configuration parameters