Rockwell Automation 2080-LC30-16AWB_16QWB_16QVB Micro830 16 Point Programmable Controllers Installation Instructions - Manual (Page 6)

6 Micro830 16 Point Programmable Controllers
Publication 2080-IN003B-EN-P - April 2014
Additional Resources
If you would like a manual, you can:
• download a free electronic version from the Internet:
http://literature.rockwellautomation.com
• purchase a printed manual by contacting your local Allen-Bradley distributor or
Rockwell Automation representative
ATTENTION:
• To comply with the CE Low Voltage Directive (LVD), this equipment must be
powered from a source compliant with the following: Safety Extra Low
Voltage (SELV) or Protected Extra Low Voltage (PELV).
• To comply with UL restrictions, this equipment must be powered from a
Class 2 or Limited Voltage Limited Current Source (LVLC).
ATTENTION:
• Be careful when stripping wires. Wire fragments that fall into the controller
could cause damage. Once wiring is complete, make sure the controller is free
of all metal fragments.
• The USB and serial cables are not to exceed 3.0 m (9.84 ft).
• Do not wire more than 2 conductors on any single terminal.
Resource Description
Micro830
®
and Micro850
®
Programmable
Controllers User Manual, publication 2080-UM002
A more detailed description of how to install and use
your Micro830 and Micro850 programmable controllers.
Micro800
®
AC Power Supply Installation
Instructions, publication 2080-IN001
Information on wiring and installing the optional AC
power supply.
Micro800 Plug-in Modules User Manual,
publication
2080-UM004
Installation and wiring descriptions for the different
Micro800 plug-in modules.
Industrial Automation Wiring and Grounding
Guidelines, publication
1770-4.1
More information on proper wiring and grounding
techniques.