Rockwell Automation 6185-K Economy Line Monitors User Manual - Manual (Page 12)

12 6185 Economy Line Monitors
Publication 6185-UM003C-EN-P
Installing Your Panel Mount Monitor
Complete the following to install your monitor:
1. Prepare panel cutout for monitor. Refer to specific cutout drawings
in Appendix B: Monitor Dimensions on page 36.
2. If access to the rear of the monitor is not available following
installation, attach the cables to the monitor at this time. Refer to the
figure on Page 15.
3. Install the monitor in the prepared cutout.
4. Install the lock nuts and washers, supplied with the monitor, around
the perimeter of the monitor. Extra lock nuts and washers are
provided.
Note: Use #10-32 or M5 self-locking nuts for mounting.
ATTENTION: You must apply nuts and washers on all
studs for NEMA 4/4X/12 fluid applications.
Mounting nuts must be tightened to a torque of 24 inch-
pounds to provide panel seal and avoid potential damage.
Allen-Bradley assumes no responsibility for water or
chemical damage to the monitor or other equipment
within the enclosure due to improper installation.
5. Tighten all mounting nuts evenly to a torque of 24 inch-pounds.