Rockwell Automation 6185-K Economy Line Monitors User Manual - Manual (Page 21)

Configuring Video Setup 21
Publication 6185-UM003C-EN-P
If you are using Windows 95, Windows 98 or Windows 2000, and your
video card supports it, you should enable your workstation to detect Plug
& Play monitors and select Plug and Play as the monitor type.
If your video card does not support Plug and Play, or if you are using
Windows NT, you should set the monitor type manually.
The possible settings are:
• “Plug and Play Monitor” - 6185-H, 6185-J and 6185-K monitors with
Plug and Play enabled system
• “Super VGA 1024x768” – 6185-H manual setting
• “Super VGA 1280x1024” – 6185-J and 6185-K manual setting
Note: These monitors use a flat panel display, but they use the
workstation’s analog VGA interface. Because of this, some
setup screens may indicate that the monitor is operating as a
CRT (analog) device, rather than a flat panel (digital)
device.
Setting the Monitor Type