Rockwell Automation 6185-K Economy Line Monitors User Manual - Manual (Page 27)

Configuring Video Setup 27
Publication 6185-UM003C-EN-P
The white pixel border on the setup screen should be visible around the
perimeter of the display.
If it is not, adjust the Horizontal and Vertical position controls until it
is.
If the Coarse adjustment was set correctly, you should be able to adjust
the Horizontal position one click to the right or left and the white border
should disappear off the respective side.
If not, readjust the Coarse setting again.
When adjusting the brightness and contrast, you want to ensure that
black appears black and white appears white and that all shades of gray
in between are visible.
These adjustments will vary depending on your lighting conditions.
Perform these adjustments under the normal operating lighting
conditions.
1. Adjust the Brightness control as high as possible while maintaining a
black bar in the top left-hand corner of the setup screen.
If this bar starts to turn gray, you have gone too far.
Figure 16
Brightness Menu
2. Adjust the Contrast control until the full range of gray scale is
visible.
Figure 17
Contrast Adjustment
If Contrast is set too high, the first gray boxes will be all white,
instead of white followed by light shades of gray.
If Contrast is set too low, a white box is not visible.
Verifying Horizontal and
Vertical Positions
Setting Brightness and
Contrast