Rockwell Automation 2198-CAPMOD-1300 Kinetix 5500 Capacitor Module Installation Instructions - Manual (Page 3)

Kinetix 5500 Capacitor Module 3
Publication 2198-IN004A-EN-P - October 2012
Before You Begin
Remove all packing material, wedges, and braces from within and around the components. After
unpacking, check the item nameplate catalog number against the purchase order.
The Kinetix 5500 servo drives are shipped with the following:
•
Wiring plug for the module status (MS) connector
•
These installation instructions, publication 2198-IN004
Install the Kinetix 5500 Capacitor Module
These procedures assume that you have prepared your panel, mounted your Kinetix 5500 servo
drives, and understand how to bond your system. For installation instructions regarding
equipment and accessories not included here, refer to the instructions that came with those
products.
Zero-stack Tab and Cutout
Engaging the zero-stack tab and cutout from drive-to-drive is required for shared-bus drive
systems and includes the Bulletin 2198 capacitor module. This is done to make sure the drive
connectors are spaced properly to accept the shared-bus connection system.
Figure 1 - Zero-stack Tab and Cutout Example
SHOCK HAZARD: To avoid the hazard of electrical shock, perform all mounting and wiring of
the Kinetix 5500 drive modules prior to applying power. Once power is applied, connector
terminals may have voltage present even when not in use.
ATTENTION: Plan the installation of your system so that you can perform all cutting, drilling,
tapping, and welding with the system removed from the enclosure. Because the system is of
open type construction, be careful to keep any metal debris from falling into it. Metal debris or
other foreign matter can become lodged in the circuitry, which can result in damage to
components.
2198-H
xxx-ERS Drive
(front view)
Zero-stack Tab
and Cutout Engaged
2198-CAPMOD-1300 Capacitor Module
(front view)