Mount the computer on a rack – Rockwell Automation 6155R 200R VersaView Industrial Non-display Computers User Manual
Page 11
VersaView Industrial Non-display Computers 11
Publication 6155R-IN001I-EN-P - July 2007
Mount the Computer on a Rack
You can install the VersaView 1400R computer in a rack cabinet that conforms to
EIA standards for equipment with 483 mm (19 in.) wide panels. The cabinet must
accommodate the computer’s 4U height and depth, and also provide rear clearance
for cables and air flow. A cabinet with a depth of 610 mm (24 in.) is sufficient.
The computer must be supported by rack slides or fastened to a shelf. The four
flanges of the computer are intended only to horizontally secure the unit to the
front mounting rails of the rack cabinet.
To locate the catalog number for the VersaView approved rack slide, go to the
website:
1. Review the product dimensions to confirm that there is adequate space
behind the cabinet for cables and air flow.
2. Install the rack slides inside the rack cabinet.
3. Attach the rack slides to the computer, aligning the rack slides to the
corresponding slides inside the cabinet.
4. Insert the computer in the rack cabinet from the front of the cabinet.
5. Fasten the two rack handles to the front of the unit by using the included
screws.
6. Horizontally secure the computer to the front mounting rails of the rack
cabinet with the included screws.
TIP
Support the computer with a shelf or other means to make
installation at the appropriate height easier.