Rockwell Automation 6155R 200R VersaView Industrial Non-display Computers - Manual (Page 17)

VersaView Industrial Non-display Computers 17
Publication 6155R-IN001I-EN-P - July 2007
Connect Power
The power connection for the computers varies by model.
• The VersaView 200R computer connects to either a 120/240V ac or
9…36V dc power source, depending on the model.
• The VersaView 700R and 1400R computers connect to a 120/240V ac power
source.
Connect ac Power
Computers with an ac power input use a standard IEC 320 power cord. The power
supply input accepts 120/240V ac and is autoranging.
Operate the computer in an industrial or control room environment, which uses
some form of power isolation from the public low-voltage mains.
ATTENTION
Connect the ac power cord to a power source with an earth ground to prevent
electrical shock. Failure to follow this warning could result in electrical shock.
The computer circuit should have its own disconnect. Use an uninterruptible
power source (UPS) to protect against unexpected power failure or power
surges.
Always shut down the operating system before removing power to minimize
performance degradation and operating system failures.
Power Input
Power Switch
VersaView 200R Computer