Rockwell Automation 2727-TRSP1xx MobileView Tablet Power Kit Installation Instructions - Manual (Page 7)

Publication 2727-IN007B-MU-P
MobileView Tablet Power Kit 7
Cleaning
Unit
Disconnect the power cord and power supply from the charger. The
case and faceplate can be cleaned using a soft cloth dampened with
water. Alcohol can be used for stubborn stains. Do not apply liquids
directly to the unit; apply sparingly on the cloth.
Contacts
The contacts on the charger and battery holders can be cleaned by
gently rubbing with a pencil eraser. Do not use abrasive or harsh
detergent cleaners.
Troubleshooting
WARNING
!
To reduce shock hazard and possible damage to the
charger, always disconnect the power cord from the
wall outlet and charger before cleaning the charger.
Table 2 Troubleshooting
Symptom/Situation
(Fault Indication) Probable Cause Corrective
Action/Solution
Charge or ready indicators
do not illuminate when
battery is inserted. Power supply cord is not
connected to wall or power
supply. Check power supply cord.
Automatic power supply
shut down. Connecting AC power
source before connecting
the power supply to the
charger. Disconnect AC power
source, wait 15 seconds,
reconnect AC power source.
Power supply power
indicator is not lit. Power supply protection
circuitry is tripped.
Bad power supply. Unplug power supply and
retry in 15 minutes.
Replace power supply.