Rockwell Automation 2090-CBKS8-16AA03 Kinetix 6000M Manual Brake Release Cable Installation Instructions - Manual (Page 3)

Kinetix 6000M Manual Brake Release Cable 3
Publication 2090-IN037B-EN-P - March 2012
Before You Begin
Remove all packing material from within and around the item. After unpacking, verify the
catalog number against the purchase order, and visually inspect the cable and each connector for
damage. If necessary, immediately notify the carrier of any shipping damage.
Cables are stored and shipped in a coil, and will retain this shape unless you straighten the cable.
To straighten a cable, hang a short cable from its mid-point or lay a long cable on the floor in a
straight line. Any coiling that persists should relax within 24 hours. Doing this results in a cable
that is easier to install.
Observe the following precautions when installing the cables in a servo system. Failure to observe
these safety notices could result in personal injury or damage to the motor and equipment.
SHOCK HAZARD: To avoid the hazard of electrical shock, be sure to ground any cable providing
power at a minimum of one point. To prevent the build-up of electrical energy, factory-supplied
cables use one of these grounding techniques:
•
Bond the overall shield to the connector housing.
•
Make sure there is a direct connection-to-ground for each cable shield.
•
Connect an exposed cable braid or a ground wire, if present, to the power cable clamp,
housing, or another suitable chassis ground.
Failure to observe these safety procedures could result in personal injury or equipment damage.
ATTENTION: Arcing or unexpected motion can occur if cables are connected or disconnected while
power is applied to the IDM system. Before working on an IDM system, disconnect power and wait
the full time interval as indicated in the warning on the IPIM module or verify the DC bus voltage at
the IPIM module measures less than 50V DC.
Failure to observe this precaution could result in severe bodily injury or loss of life, and damage to
the product will occur.
ATTENTION: The examples in this publication show the available connections, some of which may
not be appropriate for your specific installation. Refer to your system level installation instructions
or user manual for recommended wire trim lengths, and wiring examples appropriate to your
application.
Failure to observe these safety procedures could result in personal injury or damage to the motor
and equipment.