Rockwell Automation LiquiFlo 1.0 and 1.5 External Bus Resistor Kit (400 Amp) - Manual (Page 3)

Instruction Manual D2-3535 3
Step 2: Identifying the
Mounting Location Consider the following factors when choosing the location for the resistor
assembly:
• the resistor assembly must be mounted inside the drive cabinet
• the resistor assembly must be mounted vertically, with the closed part of
the protective cover pointing towards the front of the enclosure
• the wiring harness must be able to reach connectors P1 and P2 inside the
drive
• the wiring harness must not pass over unprotected sharp edges or hot
surfaces
• the resistor assembly must not be mounted on the enclosure door
Protective
Cover
Towards
Enclosure
Door
Resistor assembly shown without
harness for clarity