Rockwell Automation LiquiFlo 1.0 and 1.5 External Bus Resistor Kit (400 Amp) User Manual
Page 5
Advertising
Instruction Manual D2-3535
5
Step 4: Mounting the
Resistor Assembly
Task
Description
Using a Phillips screw driver, install and tighten the six M4 x 16 mounting screws (torque 12
in-lb)
!
ATTENTION: The cabinet can be very hot where the resistor
assembly is mounted. HOT surfaces can cause severe burns. You
must install the cabinet guard to protect personnel from
accidental contact with the hot cabinet surface.
A
Resistor assembly shown
without harness for clarity
Enclosure Wall
Mounting Screws
inserted from outside
of enclosure
A
A
A
A
A
A
Resistor assembly
mounted on inside of
enclosure
Cabinet Guard
Advertising