Rockwell Automation WebPak 3000 ControlNet Communications Board I/O with ControlLogix Processor - Manual (Page 5)

Using WebPak

3000 ControlNet

Communications Option Board I/O With a ControlLogix

Processor 5
The name of the controller tag reflects the name assigned to the WebPak 3000 drive during module
configuration. Figures 1 and 2 assume that the name Webpak1 was assigned.
The O subgroup contains one entry for each word of output data you configured and the I subgroup contains
one entry for each word of input data you configured. Refer to sections 4.2.2 and 4.2.3 in the ControlNet
Network Communication Option board instruction manual (D2-3425-2) for descriptions of output and input
words and their associated bits. Sample output and input configurations are shown in figures 1 and 2.
Figure 1 – Sample Output Configuration
Corresponds to Word 0
Drive Control Word
Corresponds to Bit 00
Section Run
Corresponds to Word 1
Speed/Torque Reference