Rockwell Automation RDD-B2153 Rotary Direct Drive Bearingless Motors - Manual (Page 4)

4 RDD-Series Rotary Direct Drive Bearingless Motor Installation Instructions
Publication RDB-IN001A-EN-P — October 2009
Before You Begin
Remove all packing material, wedges, and braces from within and around the item.
After unpacking, verify the nameplate catalog number against the purchase order.
1. Remove the motor carefully from its shipping container.
2. Visually inspect the motor frame, mounting pilot, and connectors for
damage.
3. Notify the carrier of any shipping damage immediately.
4. Retain the cardboard cover and protective paper sleeving from the mounting
end of the motor.
Required Tools
These tools are needed to install or remove the product.
ATTENTION
Magnetized material within the motor is exposed whenever the protective cover is
removed and before the motor is mounted.
Accidental entry of foreign material can harm motor performance.
Always cover the mounting end of motor immediately after removing the motor or its
protective cover. This will greatly reduce the possibility of magnetic or non-magnetic
particles accidentally entering the motor.
Tools Required Value
Hex bit, 150 mm (6 in.) minimum length 6 mm
Hex bit, 25 mm (1 in.) minimum length 8 mm
Torque wrench Capable of applying at least 45 N•m (35 lb•ft)
Screwdriver Phillips #4
Pry bar Flat blade
Micrometer N/A
Straight edge
Caliper
Runout indicator
Cleaning cloth
Flashlight