Rockwell Automation LiquiFlo 1.0 and 1.5 External Bus Resistor Kit (1200 Amp) - Manual (Page 3)

Instruction Manual D2-3537 3
Step 2: Identifying the
Mounting Location Consider the following factors when choosing the location for the resistor
assemblies:
• both resistor assemblies must be mounted inside the drive cabinet
• both resistor assemblies must be mounted vertically, with the closed part
of the protective cover pointing towards the front of the enclosure
• the wiring harness must be able to reach the connection points inside the
drive
• the wiring harness must not pass over unprotected sharp edges or hot
surfaces
• the resistor assemblies must not be mounted on the enclosure door
Protective
Cover
Towards
Enclosure
Door
Resistor assembly shown without
harness for clarity