Rockwell Automation LiquiFlo 1.0 and 1.5 External Bus Resistor Kit (1200 Amp) - Manual (Page 6)

6 Instruction Manual D2-3537
Step 5: Locating the
Connection Points and
Routing the Harness
Important: The harness connections are considered power level wiring.
Run them separately from I/O and signal wiring.
Task Description
Locate J4 on the PIC board on a LiquiFlo 1.0 drive or the PMC board on a LiquiFlo 1.5 drive
Locate CAP (-), CAP MID and CAP (+) connection points near the top of the capacitor bank
Route harness through opening on right side of drive, to the resistor assemblies
A
B
C
J4/J4A/J4B
CAP (-) and
CAP MID CAP (+)
A
B
C