Rockwell Automation CS300 Trusted Bridge Module - Manual (Page 14)

Trusted
TM
CS300 Bridge Module
Issue 02 Feb 10 PD-8162 14
The first chassis to be created is a CS300 8162. This includes the bridge modules in place of the
CS300 processors. Choose typeCS300 8162 and select a logical chassis number. This chassis
number will define the switch configuration described in section 2.3.
Figure 9 CS300 Main Chassis
The chassis should then be allocated to the Trusted TM Expander Interface module. Left-click on the left
or right end of the CS300 8162 chassis to open the Chassis Connection dialog. Select the slot number
of the left-hand Expander Interface module.
Figure 10 Chassis Connection
On closing this dialog, the CS300 8162 chassis should have a blue flash symbol on the left. The right
hand side shows the chassis address as:
< Trusted
TM expander Interface slot> - <Expander socket number> - <CS300 chassis number>
Figure 11 Connected Chassis
Left-click on the left or right end of the CS300 8162 chassis to open the Chassis Connection dialog
again. The ‘Jumper Config’ button now demonstrates how to set the backplane jumpers.