Rockwell Automation MSR42 Curtains Configuration and Diagnostic Software Tool User Manual - Manual (Page 3)

1
Light Curtain Multi-Function Control Module User Manual
Original instructions
I
All details reported by the program are for guidance only. Rockwell Automation does not give any warranty for calculations, general information, prices
or technical details about correctness and completeness.
In the interests of continual technical advancement, Rockwell Automation reserve the right to amend the specification of the products and of the prices
detailed in this software without prior notice. For further information contact your nearest Rockwell Automation sales office or Allen-Bradley
distributor.
This software is provided “as is” without warranty of any kind either expressed or implied, including but not limited to the implied warranties
merchantability and fitness for a particular purpose. The entire risk as to the quality and performance of the product is with you. Should the product
prove defective, you assume the cost of all necessary servicing or error correction. Rockwell Automation does not warrant that the functions contained
in the software will meet your requirements or that the operation of the software will be uninterrupted or error free.
In no event shall Rockwell Automation, or any other party who may have distributed the software as permitted above, be liable for damages, including
any general, special, incidental, or consequential damages arising out of the use or inability to use the software (including but not limited to loss of data
or data being rendered inaccurate or losses sustained by you or third parties or failure of the software to operate with any other products), even if such
holder or other party has been advised of the possibility of such damages.
TÜV Rheinland Product Safety GmbH, has tested the functions and the safety relevant adjustment possibilities of this software, and confirmed the
basic correct functioning of all adjustment possibilities.
Remark:
Obviously this program could not be tested with every type of computer or operating system. For that reason every result has to be proved for
plausibility. Every calculation of this program is based on standards DIN EN ISO 13855 (2010) and EN 61496-2. Special applications with their
specific standards as well as country specific directions are not taken into account. Therefore the user is responsible for the application of this program.
These products can only achieve their function as a safety controller module, if the instructions given in this
instruction manual and the within mentioned documents are exactly followed, as well as consulting the valid
laws and regulations at the time of installation.
Should these instructions not be carefully followed, serious injury or death may occur. The installer or system
integrator will be fully responsible for a safe integration of this product. In this case Rockwell Automation, or
any other party who may have distributed the software will not be liable for any damages.
The configuration of a GuardShield Micro 400 or Safe 2/4 with the MSR42 controller may only be performed
by authorized personnel. The configuration of every controller must correspond to the requirements of the
risk analysis for the monitoring of every application. An incorrect, or insufficient configuration may lead to
serious injury or even death.
To configure a unit mentioned above, a password and an Optical Interface are necessary. Both of these must
only be made available to authorized personnel.
This instruction manual is part of the controller module MSR42, GuardShield Micro 400 and Safe 2/4. It must
be kept accessible together with the other machine documentation during its entire life cycle for all
personnel responsible for assembly, installation, operation and maintenance.