Rockwell Automation MinPak Plus DC Drive Double Pole CB Kit for NRG 14C210, 14C211, 14C212, 14C213 - Manual

Reliance and MinPak are trademarks of Rockwell Automation.
© 1998 Rockwell International Corporation
Double Pole Circuit Breaker Kit
for Non-Regenerative MinPak Plus DC Drives
Model Numbers 14C210, 14C211, 14C212, and 14C213
Instruction Manual D2-3385
Product Description
The standard power on/off circuit breaker on single-phase, non-regenerative MinPak™ Plus DC drives is a
single pole, magnetic trip/manual trip unit that provides overcurrent protection for the drive’s power devices.
The Double Pole Circuit Breaker provides an additional degree of protection by removing all power from the
control circuits. When tripped, the Double Pole Circuit Breaker opens both
AC input conductors (L1 and L2)
between the drive’s power devices and drive terminal block 1TB.
The Double Pole Circuit Breaker must match the drive’s horsepower and voltage rating, as shown in table 1.
Refer to your drive’s nameplate for the horsepower rating.
The Double Pole Circuit Breaker kit includes the circuit breaker, connecting wires, and the required mounting
screws. No other options are needed when using this kit, and no user-supplied parts are required. The
contents of the kit are listed in table 2.
!
ATTENTION: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, and/or service this
equipment. Read and understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in severe bodily injury or loss
of life.
Table 1 – Verifying that the Circuit Breaker Matches the Drive
Drive
Model Number
Drive Horsepower and
Voltage Rating
Double Pole Circuit Breaker
Kit Model Number
14C10, 14C20 1/4 to 3/4 HP @ 115 VAC 14C210
14C11, 14C21 1/2 to 1-1/2 HP @ 230 VAC 14C211
14C12, 14C22 2 and 3 HP @ 230 VAC 14C212
14C13, 14C23 5 HP @ 230 VAC 14C213
Table 2 – Contents of the Double Pole Circuit Breaker Kit
Description Quantity Part Number
Double Pole Circuit Breaker 1
65241 -76A , -77A, -56C
1
1. Supplied with model numbers 14C210/14C211, 14C212, and 14C213, respectively
Jumper Wire 182 1
608813 -80Y, -80R, -80S
1
Jumper Wire 52 1
608813 -80V, -80W, -80X 1
Harness Wire 51/52 1 608813 -81R
Mounting Screw, 6-32 x 1/4 4 601742 -2C
Instruction Manual 1 D2-3385