Rockwell Automation 20D PowerFlex 700H/S Frame 9 Main Fan and Isolation Transformer Assembly Replacement User Manual
Page 7
Advertising
PowerFlex® 700H/S Frame 9 Main Fan and Isolation Transformer Assembly Replacement
7
11. Install the new main fan assembly and plug the connector of the main
fan in the connector of the isolation transformer. Place the rubber
bushing around the cable and put the cable into the bushing hole located
in the bottom of the isolation transformer assembly.
12. Bend and attach the extra wire in the fastening on the fan support (see
below).
Figure 7
Advertising
This manual is related to the following products: