Rockwell Automation SB3000 Universal Drive Controller Module - Manual (Page 2)

The information in this users manual is subject to change without notice.
Ethernet™ is a trademark of Xerox Corporation.
Multibus™ is a trademark of Intel Corporation.
AutoMax™ and PowerMax™ are trademarks of Rockwell Automation.
© 1998 Rockwell International Corporation
Throughout this manual, the following notes are used to alert you to safety considerations:
Important: Identifies information that is critical for successful application and understanding of the product.
!
ATTENTION: Identifies information about practices or circumstances that can lead to personal
injury or death, property damage, or economic loss.
The thick black bar shown at the margin of this paragraph will be used throughout this manual to indicate new
or revised text or figures.
!
ATTENTION: Only qualified personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, or service this equipment.
Read and understand this manual and other applicable manuals in their entirety before
proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: The user is responsible for conforming with all applicable local, national, and
international codes. Failure to observe this precaution could result in damage to, or destruction
of, the equipment.
ATTENTION: The user must provide an external, hardwired stop circuit outside of the drive
circuitry. This circuit must disable the system in case of improper operation. Uncontrolled machine
operation may result if this procedure is not followed. Failure to observe this precaution could
result in bodily injury.
ATTENTION: Only qualified Rockwell personnel or other trained personnel who understand the
potential hazards involved may make modifications to the rack configuration and application tasks.
Any modifications may result in uncontrolled machine operation. Failure to observe this precaution
could result in damage to equipment and bodily injury.
ATTENTION: Registers and bits in the UDC module that are described as “read only” or for “system
use only” must not be written to by the user. Writing to these registers and bits may result in
improper system operation. Failure to observe this precaution could result in bodily injury.