Rockwell Automation 1897-NOV High Speed Analog Installation Instructions - Manual (Page 3)

Fast Isolated Analog Output Module 3
Publication CIG-5.1 – April 1998
Place your module in any I/O module slot of the I/O chassis except
for the extreme left slot. This slot is reserved for PC processors or
adapter modules.
!
ATTENTION: Do not insert or remove modules from
the I/O chassis while system power is ON. Failure to
observe this rule could result in damage to module
circuitry.
Group your modules to minimize adverse affects from radiated
electrical noise and heat. We recommend the following.
•
Group analog input and low voltage dc modules away from ac
modules or high voltage dc modules to minimize electrical noise
interference.
•
Do not place this module in the same I/O group with a discrete
high-density I/O module when using 2-slot addressing.
!
ATTENTION: Remove power from the 1771 I/O
chassis backplane and field wiring arm before
removing or installing an I/O module.
•
Failure to remove power from the backplane or
wiring arm could cause module damage, degradation
of performance, or injury.
•
Failure to remove power from the backplane could
cause injury or equipment damage due to possible
unexpected operation.
Place the module in the card guides on the top and bottom of the chassis that guide the module into position.
Important: Apply firm even pressure on the module to seat it into its
backplane connector.
11
Snap the chassis latch over the
top of the module to secure it.
Swing the chassis locking bar
down into place to secure the
modules. Make sure the locking
pins engage.
1771-A1B, -A2B, -A3B1, -A4B Series B I/O chassis 1771-A1B, -A2B, -A3B, -A3B1, -A4B I/O chassis
Determine Module
Placement in the I/O
Chassis
Install the Module and the
Remote Termination Panel