Rockwell Automation VPS-B1653D-PJ12DF Kinetix VP Stainless-steel Servo Motor with 130...165 mm Frame Size Install - Manual (Page 17)

Kinetix VP Stainless-steel Servo Motor with 130 mm and 165 mm Frame Size 17
Rockwell Automation Publication VPS-IN002A-EN-P - April 2013
Adjust the Clearance between the Slinger and Motor Face
1. Position two 0.5 mm (0.02 in.) feeler gauges between the motor face and slinger,
one feeler gauge on each side of the shaft.
2. Slowly tighten or loosen the nut to adjust the slinger on the shaft.
Adjustment is complete when the slinger lightly and evenly contacts both feeler gauges.
Specifications
The exterior surfaces of the Bulletin VPS stainless steel servo motors are made from the materials
in the table. Always store a motor in a clean and dry location within the environmental
conditions.
TIP Replace the shaft key, if the motor is so equipped, after removing all tools.
Refer to
Remove and Install a Shaft Key on page 13 .
Exterior Surface Materials
Surface Material
Shaft Stainless steel - grade 303 SST
Shaft key Stainless steel - 300 series
Housing Stainless steel - grade 304
Connector Nickel-plated zinc casting
Environmental Specifications
Attribute Value
Temperature, operating 0…40 °C (32…104 °F)
Temperature, storage -30…70 °C (-2 …158 °F)
Relative humidity 5…95% noncondensing
Atmosphere Noncorrosive
Motor housings are rated with multiple International Protection Codes (IP ratings) for environmental protection.
IP66 Dust tight, powerful water jets, room temperature water (1)
(1) IP rating descriptions are for reference only. Refer to the international standards for more complete rating descriptions.
IP67 Dust tight, temporary immersion, room temperature water (1)
IP69K
Dust tight, water/steam jets up to 100 bar (1200 psi) with nozzle pressure at
approximately 80 °C (176 °F)
(1)
The connector is IP66 and IP67 rated.
(1)