Rockwell Automation SP200 AC Drive, 1 2 Channel Analog, Preset Speed - Manual (Page 45)

Editing Drive Parameters 7-23
d-06 Drive Rating
This parameter defines the drive
voltage and horsepower rating as
shown in the table below. Parameter Range: 0 to 255
Running Access: RO
ID Code
Drive HP 230 V, 1 Phase 230 V, 3 Phase 460 V, 3 Phase
0.5 0205 0205 0405
1.0 0210 0210 0410
1.5 0215 None None
2.0 0220 0220 0420
d-07 Firmware Version
This parameter represents the drive
firmware version number. Parameter Range: alphanumeric code
Running Access: RO
d-08 Analog Input 1 Units
This parameter displays the value of
the signal that is connected to the
Analog Channel 1 input on the Parameter Range: 0 to 110.0 (%)
Running Access: RO
control signal terminal block. It can be scaled by changing P-63 (Analog Input Display Units). This
parameter is used for models A and C only.
d-09 Analog Input 2 Units
This parameter displays the value of
the signal that is connected to the
Analog Channel 2 input on the Parameter Range: 0 to 110.0 (%)
Running Access: RO
control signal terminal block. It can be scaled by changing P-63 (Analog Input Display Units). This
parameter is used for model C only.