Rockwell Automation Solar Turbine Addendum Version 6.0 - Manual (Page 15)

Cabinet Mounting and Wire Routing 3-1
C
HAPTER
3
Cabinet Mounting and Wire Routing
This chapter provides information on how to mount the Solar Turbine drive. Also
shown are the entry areas where wiring is to be routed in and out of the drive.
Please refer to instruction manual D2-3360 for detailed information on planning your
drive installation and for further information on proper wiring routing of power and
signal wiring and grounding of GV3000/SE drives.
3.1 Mounting the Drive
Attach the drive to the vertical surface selected using the four (4) mounting holes
provided. In order to maintain a flat mounting surface and to ensure that bolt tightness
is maintained, use washers under the bolt heads. Refer to table 3.1 and figure 3.1 for
mounting dimensions. Use the following user-supplier mounting bolts and washers:
1 HP Solar Turbine Drives: M8 (5/16”)
5 HP Solar Turbine drives: M8 or M10 (5/16” or 3/8”)
Table 3.1 – Drive Dimensions and Weights
HP Rating Dim. A Dim. B Dim. C Dim. D Dim E. Weight
1 HP 280.6 mm
11.05"
338.4 mm
13.32"
248.0 mm
9.76"
309.1 mm
12.17"
200.0 mm
7.87"
9 kg
20 lbs
5 HP 288.0 mm
11.34"
463.0 mm
18.23"
223.0 mm
8.78"
442.0 mm
17.40"
238.1 mm
9.37"
15.75 kg
35 lbs