Rockwell Automation Solar Turbine Addendum Version 6.0 - Manual (Page 17)

Cabinet Mounting and Wire Routing 3-3
3.2 Cabinet Wire Routing
All wiring should be installed in conformance with the applicable local, national, and
international codes (for example, NEC/CEC). Signal wiring, control wiring, and power
wiring must be routed in separate conduits to prevent interference with drive
operation. Figures 3.2 and 3.3 show the wire routing of the cabinet for 1 HP and 5 HP
drives, respectively.
Refer to instruction manual D2-3360 for detailed instructions on cabinet wire routing.
!
ATTENTION: Do not route signal and control wiring with power wiring in
the same conduit. This can cause interference with drive operation.
Failure to observe this precaution could result in damage to, or
destruction of, the equipment.