Rockwell Automation MPL-xxxx Servo Motor - Manual (Page 23)

MP-Series Low-inertia Servo Motor with 100 mm to 165 mm Frame Size 23
Rockwell Automation Publication MP-IN001H-EN-P - January 2014
Motor Cables and Accessory Kits
This section describes accessories that are available for MP-Series low-inertia motors.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable lengths. They
provide the sealing needed to achieve environmental ratings and shield termination.
If you choose to build your own cables, connector kits available for MP-Series small frame
motors are described in the Kinetix Motion Accessories Specifications Technical Data,
publication
GMC-TD004 .
Shaft Seal Kits
A shaft seal is a barrier that can prevent moisture and particles from entering the motor bearings.
Shaft seals are subject to wear and require periodic inspection and replacement. Replacement is
recommended every 3 months, not to exceed 12 months, depending on use.
Catalog numbers for the motors and corresponding replacement Nitrile shaft seal kits are listed
in the table.
For instructions on how to install a shaft seal, refer to the Shaft Seal Kit Installation Instructions,
publication
2090-IN012 .
IMPORTANT Shaft seals must be lubricated. Lubricant is supplied with the shaft seal kits.
Third-party shaft seals are not approved for use with these motors. The use of third-party shaft seals voids any
implied or expressed warranties.
Motor Cat. No. Shaft Seal Kit Cat. No.
MPL-A310, MPL-B310
MPL-SSN-A3B3 MPL-A320, MPL-B320
MPL-A330, MPL-B330
MPL-A420, MPL-B420
MPL-SSN-A4B4
MPL-A430, MPL-B430
MPL-A4520, MPL-B4520
MPL-SSN-A5B5
MPL-A4530, MPL-B4530
MPL-A4540, MPL-B4540
MPL-A4560, MPL-B4560
MPL-A520, MPL-B520, MPL-A540, MPL-B540,
MPL-A560, MPL-B560
MPL-SSN-F165
MPL-B580 MPL-SSN-F165-32MM