Autocue QPro User Guide - Manual (Page 35)

QPro User Guide HM.docx 2011-07-14
35 © 2003-2011 Autocue Group Ltd.
From the list, select the controller you wish to use. If you wish to use the Default Controller, click
OK.
When you add a scroll controller for use with your software, you can configure it so that
the various buttons and wheels perform specific actions.
Note: You cannot configure scroll controls when you are in Prompt mode.
Assigning a default controller
At least one scroll control device must be defined and set as the Default Controller. This is
usually done when you first start the software.
If you want to change the default controller you must select an entry from the list of those
available and click Set Default.
If you have purchased the option to have more than one scroll controller attached to you
computer, you will be able to select and configure the Virtual Spider Box as the default
controller.
Access scroll control configuration
Highlight a scroll control device in the list of available controllers and click the Setup
button. The appropriate configuration screen for the type of controller will be
displayed.
Swapping button functions
To prevent you accidentally assigning the same action to more than one button, when
an action is selected it is removed from the available action list.
It is recommended that you first assign the action (Nothing) to a button so that the action
previously assigned becomes available to another button.
Two-button Serial Controller
Autocue’s standard scroll control has one programmable red button, a forward/reverse
button and a knurled wheel that controls the scrolling speed.