Bowers Group Advanced Electronic/Air Column PC-2200 - Manual (Page 20)

PC-2200
BOWERS METROLOGY page 20 /32 version 2.06 -E
Chapter 4. Functions
Definition of keypad functions per menu
4.1 THE MEASURING MODE FUNCTIONS
Functions Functions
Access to programming mode
“M” Change the measure number (M1-M2)
only if M2,M3,M4 (ON) M1-M2-M3-M4
“S” send the displayed value to RS232
No function in measuring mode
No function in measuring mode
Simultaneously when switching (ON) RESET
Preset
Value
M1
00.0000 Access to preset mode
Value = Norm. value + Meas. range. PRESET Maximum
+/- 0.05”
Calibration
Module M1, M2, M3,M4
CAL% Cal. Min__ and Max
Cal. by measure M1, M2, M3, M4
NONE, Value XXX%
4.2 THE PROGRAMMING MODE FUNCTIONS
Menu Sub-menu Functions Functions Functions Functions
CHANNEL
SOURCE
CH-A
CH-B
CH-C
CH-D
EXT.
CH-BUS
RATIO
RATIO
RATIO
RATIO
1.000
1.000
1.000
1.000
DIRECT
DIRECT
DIRECT
DIRECT
+ / -
+ / -
+ / -
+ / -
SOURCE : EXT. Select the source of the probe on the analog board on this column.
CH-BUS. Select the source of the probe from another column thru the CH-BUS.
CH-A : Select the ratio value and measuring direction for the channel A.
CH-B : Select the ratio value and measuring direction for the channel B.
CH-C : Select the ratio value and measuring direction for the channel C.
CH-D : Select the ratio value and measuring direction for the channel D.
Prog
M
Esc
S
Enter
Preset
Cal
Prog