Brandmotion 9002-8838 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
8838 Instructions 10-7-14.docx Page 3 of 5
Step 13: Pull out subwoofer box slightly to gain access
to run Chassis Harness along existing harness
Step 14: Pull back carpet and continue running Chassis
Harness forward.
Step 15: Run Chassis Harness under B-pillar cover to
passenger door sill. Use a plastic trim removal tool to
remove the (2) plastic push pins and remove passenger
sill plate/kick panel.
Step 16: Use a 10mm socket to remove the existing nut
located behind the passenger kick panel and attach
ground eyelet of Chassis Harness to chassis ground.
Step 17: In the factory wire harness located in the
passenger foot well, locate the White/Gray Reverse
signal wire and splice Green Reverse wire from supplied
Mirror Harness. RECOMMENDED: Use solder and cover
with heat shrink tubing or use T-tabs as an alternate
connection method.
Step 18: Remove rubber bin insert from top of dash.
Step 19: Remove 7mm bolt .
Step 20: Using a plastic trim removal tool, remove
window switch panel.