Brandmotion 9002-9560-V2 - Manual (Page 4)

INSTALLATION
INSTRUCTIONS
9560 Instructions 7-2-13.doc 4 of 7
FIGURE 10
23. Snap the supplied Tailgate Bezel Assembly into the
Tailgate.
24. Seat the second grommet (4) securely around
opening. Figure 10.
25. Install remaining Tailgate Latch Handle Bolt in
Tailgate and tighten all three 13mm bolts to 25 N·m
(18 lb ft).
26. If present, remove the Rear License Plate.
27. With the help of an Assistant, re-install the Tailgate
onto the Pickup Box, carefully routing the Camera
harness through the opening on the Pickup Box Sill.
28. Re-attach Tailgate Support Cables and close
Tailgate. Figure 11.
FIGURE 11
29. Through the License Plate Opening pull the Camera
Assembly Harness (2) until the first grommet (3) is
properly seated in the Pickup Box Sill (1). Figure 12.
FIGURE 12
Determine Reverse Signal Location
30. Using a Trim Removal Tool, remove Left Instrument
Panel Outer Trim Cover (1). Figure 13.
FIGURE 13
31. Remove M-BEC cover under the dashboard by popping
it off with hands. Figure 14.
FIGURE 14
32. Have an assistant set parking brake, start vehicle,
and shift into Reverse. Using a digital multimeter,
check for Reverse signal in Cavity 5 at the Light
Gray C11/X11 Connector OR Cavity 8 of Gray C10/
X10 Connector in the M-BEC. Figures 15, 16, and 17.