Brandmotion 9002-9560-V2 - Manual (Page 5)

INSTALLATION
INSTRUCTIONS
9560 Instructions 7-2-13.doc 5 of 7
FIGURE 15
FIGURE 16
FIGURE 17
33. If Reverse signal is NOT present in the C10/ X10
Connector or C11/ X11 Connector:
A. Check that bail that secures the M-BEC
connectors is fully locked. Repeat Step 33.
B. If Reverse signal is still not present, check Fuse
Block for any blown fuses. Figure 15. Replace
any blown fuses and repeat Step 33.
C. If Reverse signal is still NOT present,
connection to Reverse signal must be made at
the BCM rather than the C10/ X10 or C11/ X11
Connector (refer to Step 50 under “Install
Chassis Harness & Connect to Aftermarket/ NAV
Display”).
Cut Accessory Pass-Through in Front of
Dash
34. Remove Parking Brake Release Handle Bolt and the
Handle. Remove two Knee Bolster Assembly Screws
(1) and Knee Bolster Assembly (2). Figure 18.
FIGURE 18
35. Disconnect the electrical connections, if applicable.
36. Disengage the M-BEC (1) from support bracket.
Figure 19.
FIGURE 19