Brandmotion FDMC-1261 - Manual (Page 4)

INSTALLATION
INSTRUCTIONS
1261 Instructions 9-12-14.doc Page 4 of 5
Step 12: Using Trim Removal Tool loosen
lower side console trim.
Step 13: Using 7mm Nut Driver remove 7mm
nut,
Step 14: With trim loosened reach behind
keyed power point and disconnect at
connector.
Step 15: Splice Red wire of Power Harness to
the Red/Yellow (12v ignition) wire of the
power point plug and Splice Black wire of
Power Harness to the Black (ground) wire of
the power point plug
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing.
Step 16: Run Power Harness along console
side panel reward towards armrest bin.