Brandmotion FDMC-1261 - Manual (Page 5)

INSTALLATION
INSTRUCTIONS
1261 Instructions 9-12-14.doc Page 5 of 5
Step 17: Drill 1/2” hole through lower
armrest bin side panel 1 ½” below top lip on
passenger side of vehicle.
Step 15: Run harness through ½” hole into
armrest bin.
Step 15: Connect Power Harness to Charging
Module.
Step 16: Install Non-Slip Freedom Charge
Mat to Wireless Charging Module. Place the 4
locator pins in corresponding holes.
Step 17: Test system. LED light will
illuminate Blue once accessories are on.
Once Qi equipped device is placed on
Freedom Charge LED will illuminate Green
and charging begins. *Please note on some
devices syncing may take up to 15 seconds. Coil
locations vary on various devices; move device on
mat until LED illuminates green.
Step 18: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
Step 19: Place removable consumer product
label on center of mat.