Brandmotion FDMC-1262 - Manual (Page 4)

INSTALLATION
INSTRUCTIONS
1262 Instructions 9-14-14.doc Page 4 of 5
Step 12: Remove 7mm bolt.
Step 13: Remove driver knee bolster cover.
Step 14: Remove (2) 7mm bolts on both
sides of the steering column.
Step 15: Remove center stack/cluster
surround.
Step 16: Using a plastic trim removal tool,
remove HVAC panel to access power point.
Step 17: Splice Red wire of Power Harness to
the Blue/Red (12v ignition) wire of the
keyed accessory power point plug and Splice
Black wire of Power Harness to the Black
(ground) wire of the power point plug
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing.