Brandmotion FDMC-1262 - Manual (Page 5)

INSTALLATION
INSTRUCTIONS
1262 Instructions 9-14-14.doc Page 5 of 5
Step 18: Run Power Harness along console
side panel reward towards armrest bin.
Step 19: Run harness through ½” hole into
armrest bin.
Step 20: Connect Power Harness to Charging
Module.
Step 21: Test system. LED light will
illuminate Blue once accessories are on.
Once Qi equipped device is placed on
Freedom Charge LED will illuminate Green
and charging begins. *Please note on some
devices syncing may take up to 15 seconds. Coil
locations vary on various devices; move device on
mat until LED illuminates green.
Step 22: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
Step 23: Place removable consumer product
label on center of mat.